Pre-Cut 1/8" PowerGrip Rubber Rolls

When installing rolled rubber flooring, it is recommended to use an adhesive to prevent the rolls from moving or sliding apart. The two most common methods of adhering rubber rolls to the subfloor are:

A: Double-Sided Tape Installation:

• Clean the subfloor of all dust, dirt, and debris.
• Loose lay the rolls in the desired room configuration and let them relax for 24-48 hours.
• Ensure roll colors match and make any necessary cuts.
• Roll up one end of the rolls and apply double-sided tape to the floor along the perimeter of each roll.
• Place the rubber rolls back into position on top of the double-sided tape.

B: Glue Installation

• Clean the subfloor of all dust, dirt, and debris and ensure it is free of moisture.
• Loose lay the rolls in the desired room configuration and let them relax for 24-48 hours.
• Ensure roll colors match and make any necessary cuts.
• Roll up one end of the rolls and spread a light layer of polyurethane adhesive that is 10’ long (maximum). Unroll the flooring into the adhesive 10’ at a time.
• Repeat this step for every 10’ of roll length until the entire roll has been unrolled into its desired position.
• Use a 100-pound roller on the floor to guarantee good adherence to the subfloor or walk on the flooring in small choppy steps.

• Vacuuming any loose dust, dirt, or debris from the flooring surface when necessary.
• Occasional damp mopping of the rolls with a mild soap and water mixture. Some soaps commonly used include Dawn dish detergent and/or Tide laundry detergent.

Note: Do not use solvent or oil-based cleaners such as Pinesol, Lysol, Murphy’s Oil Soap, WD40, paint thinner, etc., as these will break down the flooring over time.